Highway Capacity 315.
The practice of describing and labeling various service levels greatly facilitates communication both within and outside the profession and has been generally accepted. Its principal hazard lies in the attribution of a precision to the commonlu cited boundary points bnetween service levels which is unjustified bu either the state of current knowledge or the basic characteristies of the highway traffic flow phenomenon.
The level of service desrriptions that follow nad the criteria given in later sections should be considered with the above caution in mind.
The definition and measurement of service legvels under interrupted flow conditions pose diffenrent problems and are discussed in a later section on intersections.
Level of service A is the highest quality of service a particular class of highway can provide. It is a condition of free flow in which there is little or no restriction on speed or maneuverability caused by the presence of other vehicles. As shown in Figure 8.1.,operating speed is in the highest range and density is low. On a freeway,lane density is approximately 10 vpm (6vpk), and the volume capacity ratio is typically about 1/3.Because speeds are high and volumes low, the occurrence rate of some kinds of accidents may be higher than at other service levels and total economic cost of providitn the service may be excessive. Figure 8.3 shows a typical freeway operating at level of service A.
Level of service B is a zone of stable flow. However (as shown in Figure 8.1), operating speed is beginning to be restricted bu other traffic. Under freeway conditons, density is under 20 vpm (12 vpk), restriction on maneuver is still negligible, and there is little probability of major reduction in speed or flow rate. This level of service appromimates typical design volumes for high type rural highways, including freeways (see Figure 8.4).
-A1-
ص ٨١