مستخلصات رسائل السعوديين لدرجة الدكتوراة — الصفحة ٥٦٩

Technology 415 analysis of the flexural behaviour of beams at ambient and elevated tempera- ture; and new approaches were proposed for the determination of the flexural stress block and the design of beams in general and R.C. beams in particular. The experimental investigation was carried out on three types of specimens. Pull-out prisms, 100 mm. square and 150 mm. long, containing a 6 mm. diame- ter round steel reinforcement were used to determine the bond strength. Con- crete cylinders, 50 mm. diameter and 150 mm. long, were used for the determi- nation of the behaviour of concrete in compression. Plain and reinforced con- crete beams, 50 x 75 x 850 mm., were used to determine the flexural properties of concrete and the behaviour of beams. The tests were carried out at the temperature steady state, the load-temperature transient state, and the temperature transient state. Specimens were loaded in the steady state when their temperature reached, and was maintained at, the required level; in the load-temperature transient tests, the specimens were subjected to load and temperature simultaneously; and in the temperature transient tests, the speci- mens were heated while the load was maintained at a constant level. The varia- bles measured during the tests were: temperature, load, deflection, strain, free thermal expansion, shrinkage and loss of weight of the specimens. Extra tests were carried out, in the temperature range 20-110°C., on normal-weight con- crete beams to compare their behaviour with that of lightweight concrete. Strain measurements were made in special ambient-temperature tests of light- weight aggregate (Aglite) concrete and reinforced concrete beams to compare the experimental and theoretical results. Analytical solutions were developed for the determination of the behaviour of flexural members subjected to moments and transverse loads. The analysis is based on the concept of varying shape and size of the stress block during load- ing; it, also, incorporate the effects of the differential thermal movements, where reinforcement is present, due to shrinkage or temperature increase. Close agreement was obtained between the experimental results and those pre- dicted by the analysis; due to inadequacy of data, the comparison at elevated temperature was less than satisfactory in terms of numerical values although the trends of behaviour were similar. Charts containing information on the load-carrying capacity and strains at various levels of load, from which deflec- tions can be calculated, were suggested for the design of R.C. beams. These ob- viated the need for basing limit state design on two separate, and incompatible, concepts, i.e., non-linear stress strain curve for the calculation of moments of resistance, and a linear curve for the calculation of deflections.
ص ٥٦٩

النص مستخرج آليًّا من صور الكتاب، وقد يقع فيه خطأ.