مستخلصات رسائل السعوديين لدرجة الدكتوراة — الصفحة ٤٠٩

Pure Sciences 255 sulphate from sulphonate. The inorganic sulphate left in the aqueous phase is determined after the addition of phosphoric acid. Of methods used for the total sulphur determination in detergent, (hydrogen peroxide oxidation, acid de- composition, alkali fusion and oxygen flask combustion), the combustion me- thod is recommended because of its efficiency. The method was applied to the separation and determination of the sulphonate4 and sulphate content of com- mercial detergents. Chapter V descrones a direct, rapid method for the determination of ppm of phosphorus in detergents. The samples were asked to remove the effect of or- ganic matter. Sulphuric acid was added to remove cationic interferences and the green HPO emission measured at 528 nm. In Chapter VI, some studies are made on the behaviour of gallium in the ME- CA cavity in the hydrogen-nitrogen-air flame. A method has been established for the determination of <10 ppm of gallium based on the measurement of the violet Gal emission at 391 nm, and also for the determination of μg amounts of iodide. Gallium was also determined by measuring the blue GaBr emission at 350 nm, but this was less sensitive tha the Gal emission. It was observed that io- dide enhanced the emission of GaBr at 350 mm. Chapter VII provides a general discussion and conclusion. 158 Al-Zamil, Ibrahim Z., Some applications of atomic and molecular emission cavity analysis. Uni- versity of Birmingham, 1978. 226 p. This thesis is divided into two parts The First Part is concerned with some analytical applications of Molecular Emission Cavity Analysis (MECA); the Second Part is devoted to investiga- tions of the anlytical utility of Atomic Emission Cavity Analysis (AECA). The most important aspects of flame emission spectrophotometry are dis- cussed and the analytical applications of flame molecular emission methods based on conventional nebulization and MECA for the determination of non- metals and metalloids are reviewed. MECA is applied to the determination of tin after its reduction to stannane by sodium borohydride. The Sn0 emission produced in the MECA oxy-cavity is measured at 408 nm in a hydrogen-nitrogen glame. From 0.2 to 50 μg of tin(II)
ص ٤٠٩

النص مستخرج آليًّا من صور الكتاب، وقد يقع فيه خطأ.